No, we only sell automation systems.
We have integrated our system with many manufacturers and successfully automated any size opening they make.
Approximately eight (8) inches on the side of the door where the panels stack when open.
Our system requires a 15 amp dedicated electrical circuit with an outlet located next to the automation panel. The panel comes equipped with a cord that plugs into the outlet. Our equipment is compatible with the electrical supply common in many countries – 120/60/1 or 240/50-60/1.
The system comes with three (3) standard safety features: motion sensor, clutch, and pressure sensitivity.
No, the system is extremely quiet due to its unique design and the fact that the drive motor is installed inside a wall cavity.
There is virtually zero maintenance on the operator system. The most important thing is to keep the telescopic door floor track clean and free of debris.
The system comes with a 5 button wall switch that allows you to open, close, stop or unlock the door. One of the buttons also allows you to reset the system.
Yes. Once you push the unlock button on the wall switch or remote, you can move the door manually.
Our automation panel includes a battery back-up in case that happens. If the outage lasts more than 24 hours, it may be necessary to reset the system by following the simple instructions in the Owner’s Manual.
Our automation system is sold through regional dealers. The cost can vary according to the door size and construction methods used in your area. Also, the system required can be affected by the multi-slide door size and configuration. Please contact the dealer in your area to get a specific price for the system.
A minimum of 3/4” is necessary above the door in the head track.
The panel itself is 18” x 12” x 6”. And you can mount it a maximum of 75 feet from the motor assembly.
Usually, it is best at the jamb.
Please see out application for a Dual Panel System in this case.
Our Series 200 is more than adequate.
We offer an outdoor secure keypad, different remotes and a touch screen. We can also be used with an IPad or other such devices.
It is a reliable 24 volt model.
Absolutely, we work with Crestron, Lutron, Control 4 and Savant..to name a few.
No, solo vendemos el sistema de automatización.
Nuestro abridor ha sido integrado a varios fabricantes y exitosamente hemos automatizado sus puertas correderas sin importar el tamaño de la apertura.
Aproximadamente 8 pulgadas (203mm) en el lado que se apilan las hojas correderas cuando están abiertas.
El sistema automático requiere un circuito dedicado de 15 AMP con un tomacorriente junto al panel de automatización. El panel incluye un cable que se conecta directamente al tomacorriente. Nuestro equipo es compatible con los suministros eléctricos en muchos países- 120/60/1 ó 240/50-60/1.
El sistema abridor cuenta con tres (3) características de seguridad: un sistema de embrague, detector de movimiento y sensor de presión.
No, el sistema motorizado es silencioso gracias a su diseño y a que sus componentes se colocan en una cavidad dentro de la pared.
Realmente no necesita ningún mantenimiento con tal de que la vía inferior de las puerta telescópica se mantenga limpia.
El sistema incluye un interruptor de pared con cinco (5) botones que le permite abrir, cerrar, detener y desactivar la cerradura automática. El quinto botón es para reiniciar el sistema.
Sí. Solo tiene que presionar el botón “unlock” en el interruptor de pared o el control remoto.
Gracias a una batería de respaldo (incluida) no tiene por qué preocuparse. (Nota: En caso que la interrupción dure más de 24 horas, entonces deberá seguir las instrucciones del manual de usuario para reiniciar el sistema.)
El sistema Doors In Motion se vende a través de representantes regionales. El costo puede variar dependiendo del tipo de construcción donde usted vive y el tamaño y configuración de las puertas corredizas. Le invitamos a comunicarse con un representante en su región para una cotización.